You are at
home
products
Panel Core Loading and End Milling machine
Panel Core Loading and End Milling machine
|
This machine is automatically feeds the pre-cut sheets past specially designed cutting heads,
both squaring and milling a special trapezoidal finger joint into the core sheets. It then automatically feeds the sheets into the panel machine, completely eliminating the manual sheet loading process. Built to the length of your core sheets, the machine can handle sheets from 50 - 300mm thick in EPS, XPS, Xflam, PU and any other rigid Core material (Not Mineral wool)
Specification:
- Maximum Line speed: 5m/min
- Maximum Core Thickness: 300mm
- Minimum Core Thickness: 50mm
- Power Requirement: 380-415VAC 3 PH. 15 Amps
- Compressed Air: 5 l/min FAD 600 kPa Pressure.
- Requires Connection to an Extraction System
- Consumables: Trimmer Blades,
|
